Copper-to-copper and copper-to-brass sweat .brass fittings connections are very uncomplicated to make should you it right when, and notoriously difficult fix if you make miscalculation. The trick to get it right would be to spend time to properly prepare the pipe and valve unless you apply the torch. Which means that de-burring the pipe, washing the pipe and valve thoroughly and applying flux carefully. When the copper shines with the torch flame, the flux bubbles and the solder wicks seamlessly to your joint, you'll know the other effort was important.

1 Put off the everyone who is installing a valve inside an active water line. This may increasingly involve turning over water about the entire house. Open the faucets to let your drain.

2 Cut the copper pipe by having a pipe cutting tool. Tighten the clamp throughout the pipe therefore blade digs to qualify for the pipe, and twist the cutter about the pipe once. Tighten the clamp slightly and twist it around again. Continue for implementing this before pipe separates.

3 Ream within the pipe with the reaming tool about the end inside the pipe cutter, or get a file.

4 Abrade the pipe plus the female ends of your ball valve by brushing. brass gate valves well which has a wire brush. Might remove oxidized copper. Remove all bits of metal which includes a clean rag.

5 Brush plumbing flux generously on top of the not in the pipe and therefore the within the ball valve fitting, guaranteeing to fund all surfaces completely. Make use of brush offered the flux.

6 Slip the pipe on the valve and ensure it's completely seated. Heat the joint using propane torch, holding the torch about 4 inches away and moving it slowly inside the joint. The pipe gets shiny originally and then suddenly darken due to the fact flux starts to sizzle and smoke. At this point, move the flame away.

7 Touch the end of the solder wire into your joint. Upon a vertical connection, slowly move it entirely surrounding the joint, allowing the solder to melt and wick in. Start at the end of your horizontal connection and steer the important towards far wall, ending at the bottom.

8 Switched on the river once any other connections.brass ball valve appear to have been made and check the joint for leaks.