Copper-to-copper and copper-to-brass sweat .brass ball valve connections may be effortless make if you it right initially, and notoriously difficult fix if one makes an error in judgment. The true secret for you to get it right s always to make time to properly prepare the pipe and valve before you can apply the torch. Meaning de-burring the pipe, washing the pipe and valve thoroughly and applying flux carefully. As soon as the copper shines in the torch flame, the flux bubbles plus the solder wicks seamlessly within the joint, you know any additional effort was worth purchasing.

1 Pull the plug on the sea if you're installing a valve on an active water line. May involve turning from all the water into the entire house. Open the faucets to allow the tank drain.

2 Cut the copper pipe which also has a pipe cutting tool. Tighten the clamp for the pipe before the blade digs straight into the pipe, and twist the cutter round the pipe once. brass stop valves tighten the clamp just a little and twist it around again. Continue with this just before pipe separates.

3 Ream the inside of the pipe with the reaming tool within the end of these pipe cutter, or make use of a file.

4 Abrade the pipe and female ends of your ball valve by brushing well with a wire brush. This would remove oxidized copper. Remove all round the metal by having a clean rag.

5 Brush plumbing flux generously on top of the away from the pipe and in addition the as a part of ball valve fitting, confirming to pay all surfaces completely. Utilize brush forwarded to the flux.

6 Slip the pipe in the valve assure its very seated. Heat the joint utilizing a propane torch, holding the torch about 4 inches away and moving it slowly across the joint. The pipe will be shiny firstly and then darken for the reason that flux starts to sizzle and smoke. Will be, move the flame away.

7 Touch the end of the solder wire on the joint. Around a vertical connection, slowly move it completely surrounding the joint, allowing the solder to melt and wick in. Start towards the end of a horizontal connection and get your blood flowing the premium toward the medial side, ending in the bottoom.

8 Fire up the h2o once some other connections.brass fittings are usually made look the joint for leaks.