Copper-to-copper and copper-to-brass sweat connections are very not a worry to make if so it right at first chance, and notoriously challenging to fix if one makes a blunder. The crucial to obtaining it right is always take the time to properly prepare the pipe and valve when you apply the torch. brass ball valve this simply means de-burring the pipe, cleansing the pipe and valve thoroughly and applying flux carefully. Where the copper shines underneath the torch flame, the flux bubbles and also solder wicks seamlessly directly into joint, you will know any additional effort was considerable.

1 Disconnect the actual when you find yourself installing a valve in the active water line. It could involve turning in the water to the entire house. Open the faucets to permit the tank drain.

2 Cut the copper pipe having pipe cutting tool. Tighten the clamp over the pipe as a result the blade digs within the pipe, and twist the cutter in the pipe once. Tighten the clamp a tad and twist it around again. Continue like this up to the pipe separates.

3 Ream the interior of the pipe from the reaming tool within the end from the pipe cutter, or employ a file.

4 Abrade the pipe and also female ends within the ball valve by brushing well by having a wire brush. That should remove oxidized copper. Remove all items of metal using clean rag.

5 Brush plumbing flux generously on the away from the pipe and within the ball valve fitting,brass bibcocks being sure to cover all surfaces completely. Build brush supplied with the flux.

6 Slip the pipe in to the valve and be sure its very seated. Heat the joint employing a propane torch, holding the torch about 4 inches away and moving it slowly about the joint. The pipe might become shiny originally and after that darken to be the flux actually starts to sizzle and smoke. When this happens, move the flame away.

7 Touch the end of the solder wire with the joint. On top of a vertical connection, slowly move it completely on the joint, allowing the solder to melt and wick in. Start in the bottom of your respective horizontal connection and get your blood circulating the best towards opposite side, ending at the base.

8 Activate the ocean once other connections.brass fittings happen to have been made and view the joint for leaks.